Abstract
Abstract The impact of grafted surface of cellulose fibers on the mechanical and physical properties of fiber-cement composites (FCC) has been investigated. The grafting was performed with n-octadecyl isocyanate [i.e., with an aliphatic isocyanate (AI)], with the intention to protect the cellulose fiber from alkali degradation in the cement matrix. The chemical changes, observed by contact angle measurements and X-ray photoelectron spectroscopy, showed a higher hydrophobic character of AI-treated fibers. The strength of FCC was tested during 28 days of curing treatment. The extracted AI-treated fibers contributed to higher specific energy and final specific deflection after accelerated aging cycles in comparison with the reference composites reinforced with untreated fibers. The higher values of limit of proportionality and modulus of elasticity for composites with AI-treated fibers are an evidence of the densification of the fiber-matrix transition zone. The modulus of rupture values were higher for composites with AI-treated and Soxhlet-extracted fibers after 200 soak and dry aging cycles. In comparison with the reference, AI-treated fibers decreased the water absorption and the apparent porosity of the FCC. The modification of fibers could be a new strategy to improve the performance and stability of cement products reinforced with natural fibers.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.