Abstract
The characteristics of electrodeposited Iridium oxide films (EIROF), and Ruthenium oxide films (RUOF) under normal and annealed conditions have been investigated. RUOFs were sputter deposited onto a substrate whilst EIROF sensors were made by electrodeposition. The adhesion of the RUOF sensors was investigated on Platinum and Titanium surfaces. The electrical impedance of the two metal oxides was measured in PBS demonstrating that both films have up to a 100 fold higher electrical double layer capacitance than bright Platinum electrodes. The EIROF films show super-Nernstian response, but the formal potential shows a continuous drift with time of approximately 2 mV day−1, measured over 40 days. Both RUOF sensors show approximately Nernstian behaviour. Short term pH precision of the annealed RUOF falls within a confidence interval of ± 0.1 pH, and stability is maintained within a confidence of ± 0.24 pH for up to 147 days. The un-annealed RUOF maintains the same precision but only for 20 days. Compared to EIROF sensors, no drift correction is required for the annealed RUOF making this metal oxide suitable for long term measurements where re-calibration is not possible.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
