Ion beam induced luminescence: Relevance to radiation induced bystander effects

Abstract

The aim of this work is quantify the light emitted as a result of charged particle interaction in materials which may be of relevance to radiation induced “bystander effects” studies. We have developed a system which employs single photon counting to measure the light emitted from samples irradiated under vacuum by a charged particle beam. The system uses a fast photomultiplier tube with a peak cathode response at 420nm. It has been tested in a proof-of-principle experiment using polystyrene targets. Light output, as a result of irradiation, was measured. The luminescence yield appears to have a non-linear behavior with the incident ion fluence: it rises exponentially to an asymptotic value. The target was irradiated with beam energies varying from 1 to 2MeV and showed saturation at or before an incident fluence rate of 3×1013H+/cm2s. The average saturation value for the photon output was found to be 40×106cps. Some measurements were performed using filters to study the emission at specific wavelengths. In the case of filtered light measurements, the photon output was found to saturate at 28×103, 10×106, and 35×106cps for wavelengths of 280±5nm, 320±5nm and 340±5nm respectively. The light output reaches a maximum value because of damage induced in the polymer. Our measurements indicate a “damage cross section” of the order of 10−14cm2. The average radiant intensity was found to increase at wavelengths of 280 and 320nm when the proton energy was increased. This was not found to occur at 340nm. In conclusion, the light emission at specific wavelengths was found to depend upon the incident proton fluence and the proton energy. The wavelengths of the emitted light measured in this study have significance for the understanding of radiation induced bystander effects.