Abstract
The electrochemical activation of oxygen is the cornerstone of electrochemical conversion and storage devices, such as fuel cells, metal-air batteries, and electrolysers. It is well established that Pt is the only metal that can catalyse efficiently the oxygen reduction reaction (ORR) in acidic electrolyte, the reaction limiting the performance of low temperature proton-exchange membrane fuel cells (PEMFCs). However, due to the high cost and scarcity of Pt, research efforts recently focused on enhancing simultaneously its intrinsic activity (specific activity i.e. the current produced per cm2 of Pt) and its mass activity (the current produced per gram of Pt). Studies on Pt or PtNi single crystals have established that the ORR is a structure sensitive reaction, which is best electrocatalyzed on (111) facets in acidic electrolyte. Combining alloying and ensemble effects recently led to 20-30-fold enhancement of the specific activity for the ORR on PtNi/C nanooctahedra relative to Pt/C nanoparticles. However, due to the highly oxidizing conditions of the PEMFC cathode (high electrochemical potential, presence of oxygen, acidic pH), the stability of these “dream” catalysts was found poor in PEMFC cathode operating conditions, thus compromising their utilization in real devices 1. Strikingly, it also turned out recently that alloyed but structurally-disordered nanocatalysts, such as hollow PtNi/C nanoparticles, porous PtNi/C nanoparticles, PtNi aerogels or PtNi nanosponges also feature highly desirable and sustainable ORR activity (x 10-12 in specific activity relative to pure Pt/C). Even more striking, the ORR kinetics depends on the concentration of structural defects: the higher the structural disorder in a given nanocatalyst, the best is its intrinsic activity for the ORR but also other oxidation reactions 2. This talk will address our recent insights about the quantification and the role played by structural defects in heterogeneous electrocatalysis from the beaker cell to the fuel cell device. Our proposal is based on Rietveld refinement of wide angle high energy X-rays scattering measurements and high resolution electron microscopy for a broad range of nanocatalysts combined with density functional theory calculations (DFT) 3.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.