(Invited, Digital Presentation) Photovoltaic Applications Using Energy Transfer Characteristics from Quantum Dots

Abstract

Silicon-related materials are most commonly used in solar cells and become now an invaluable material. However, a reported maximum energy conversion efficiency of Si solar cell is close to reaching its theoretical limits. To further improve the cell performance and create new functions, it will become increasingly important to functionalize Si materials using nanostructures. One- and zero-dimensional Si nanostructures called Si nanowires (SiNWs) and Si quantum dots (Si QDs) are increasingly being used as new solar cell materials. Our group has shown that the conversion efficiency of solar cells can be increased by the non-radiation energy transfer (NRET) from Si QDs [1]. Recently, research has been developed on compound semiconductor QDs and perovskite QDs, and the conversion efficiency has been successfully increased [3-7].n-type SiNW arrays were fabricated by electroless etching and Bosch & nanoimprint lithography followed by CVD process. The CVD process was performed to form p-type Si layer for pn homojunction. Hybrid heterojunction cells of PEDOT:PSS and n-SiNWs were also fabricated. Passivation by ozone and hydrogen were applied to improve the solar cell properties [2]. After the cell fabrications, the solar cells were coated with Si QDs, CdZnS/ZnS QDs, CdZnSe/ZnS QDs and perovskite QDs. The fabrication methods and conditions of QDs have been reported elsewhere [1-7]Energy transfer effects such as NRET are new ways of increasing solar cell efficiency. To effectively use the NRET effect, the surface of Si QDs should be fully passivated by ligand molecules. The NRET process is a highly distance-dependent phenomenon, and its dependence on the length of the passivation ligands clearly showed this. NRET efficiency was increased by shortening the ligand length from 1-octadecene to 1-octene, resulting in higher JSC, ultimately providing higher energy conversion efficiency. The efficiency was increased about 1-2 % by adding SiQDs. We also observed the same effect for CdZnS/ZnS QDs, CdZnSe/ZnS QDs and perovskite CsPbCl3 QDs. In these cases, in addition to the NRET effect, the radiative energy transfer (RET) effect also contributes to the increase in conversion efficiency.