(Invited) 3D-Catenated EMImCl/(TiCl4)1.4/(δ-MgCl2)x Ionic Liquid Electrolyte for Mg Secondary Batteries

Abstract

The rapid advance in the fields of portable electronics, load leveling and peak shaving for the power grid and zero-emission automotive applications require the development of new and improved electrical energy storage systems [1,2]. Since the 90’s major improvements have been achieved in magnesium battery technology [3-6]. In comparison to Li, Mg offers the following advantages: (i) a higher volumetric capacity (3832 vs. 2062 mAh·cm-3); (ii) far greater abundance in the Earth’s crust, lowering the costs; (iii) a safer operation and a better compatibility with the environment; and (iv) an acceptable standard reduction potential (-2.36 vs. -3.04 V) [7-9]. The main roadblock for these devices is the development of an efficient and stable electrolyte that is able to reversibly deposit and strip magnesium. Although Grignard and other organo-magnesium compounds exhibit good electrochemical performances [9], they do not exhibit an optimal stability due to their high vapor pressure and flammability. Ionic liquids dissolving a Mg salt with a high crystalline disorder were proposed as promising alternative electrolytes to organo-Mg systems owing to their good electrochemical performance and lack of flammability and thermal stability issues [10]. In the present work a new family of electrolytes is proposed, based on 1-ethyl-3-methylimidazolium chloride (EMImCl), titanium(IV) chloride (TiCl4) and increasing amounts of δ-MgCl2. Specifically, four EMImCl/(TiCl4)1.4/(δ-MgCl2)xelectrolytes, with 0.00 ≤ x ≤ 0.23 are prepared and extensively characterized. The chemical composition was determined by Inductively-Coupled Plasma Atomic Emission Spectroscopy (ICP-AES). The thermal stability was gauged using High-Resolution Thermo Gravimetric Analysis (HR-TGA) and the phase transitions are highlighted with Modulated Differential Scanning Calorimetry (MDSC). Chemical interactions were studied through Fourier-Transform spectroscopy in the medium and far infrared (FT-MIR and FT-FIR) regions and confocal micro-Raman spectroscopy. The electrochemical performance was studied with: (i) Cyclic Voltammetry (CV), to probe Mg deposition and stripping (Fig. 1); (ii) Linear Sweep Voltammetry (LSV), to evaluate the electrochemical stability window; (iii) Chronopotentiometry (CP) experiments coupled with ICP-AES, to confirm and quantify the Mg deposition; and (iv) Broadband Electrical Spectroscopy (BES), to elucidate the long-range charge migration mechanisms of the electrolytes. High level density functional theory (DFT) based electronic structure calculations were undertaken to elucidate structures and vibrational frequency assignments. References 1 M. Armand and J. M. Tarascon Nature 451, 652-657, (2008). 2 B. Dunn, H. Kamath and J. M. Tarascon Science 334, 928-935, (2011). 3 V. Di Noto and M. Fauri, Batterie Primarie (Non Ricaricabili) e Secondarie (Ricaricabili) a Base di Elettroliti Polimerici Basati su Ioni Magnesio, PD99A000179, (1999). 4 V. Di Noto and M. Fauri, Magnesium-based Primary (Non Rechargeable) and Secondary (Rechargeable) Batteries, PCT/EP00/07221, (2000). 5 V. Di Noto, M. Fauri, G. De Luca and M. Vidali, (1998). 6 V. Di Noto, S. Lavina, D. Longo and M. Vidali Electrochim. Acta 43, 1225-1237, (1998). 7 D. Aurbach, G. S. Suresh, E. Levi, A. Mitelman, O. Mizrahi, O. Chusid and M. Brunelli Adv. Mater. 19, 4260-4267, (2007). 8 T. D. Gregory, R. J. Hoffman and R. C. Winterton J. Electrochem. Soc. 137, 775-780, (1990). 9 J. Muldoon, C. B. Bucur, A. G. Oliver, T. Sugimoto, M. Matsui, H. S. Kim, G. D. Allred, J. Zajicek and Y. Kotani Energy and Environmental Science 5, 5941-5950, (2012). 10 F. Bertasi, C. Hettige, F. Sepehr, X. Bogle, G. Pagot, K. Vezzù, E. Negro, S. J. Paddison, S. G. Greenbaum and M. Vittadello ChemSusChem 8, 3069-3076, (2015). Figure 1