Investigations on Effect of Lift and Wall Lubrication Forces on the Subcooled Flow Boiling

Abstract

Abstract Subcooled flow boiling is widely used as a mode of heat transfer in many industries, especially in nuclear reactors. Despite its advantages, the heat transfer is hampered beyond a certain flux due to a phenomenon known as departure from nucleate boiling (DNB). It is important to determine the void fraction profiles, especially the near-wall void fractions, to evaluate the limiting heat flux conditions. The two-fluid Eulerian model, coupled with the heat flux partitioning model, is widely used to predict subcooled flow boiling characteristics. Over the years, many researchers have not considered lift and wall lubrication forces in their modeling of subcooled flow boiling. Few researchers have considered the Tomiyama model for lift force; however, their results were not encouraging. Moreover, there is no systematic study in evaluating the impact of lift and wall lubrication forces on subcooled flow boiling. In this paper, various lift and wall lubrication models are compared to understand the implications of these forces on void distribution. The advantages and limitations of the models are discussed in detail.