Abstract
Sharp leading edges with a millimeter-scale radius are required for hypersonic vehicles from aerodynamic reasons. However, with the leading edges being so sharp, stagnation regions at wing and tail leading edges suffer a hostile thermal environment. Therefore, a high-temperature heat pipe is considered to be integrated into the structure of the leading edge to reduce the temperature of the stagnation point. In this paper, a superalloy-refractory composite-container-“wall” combined with the wick and working fluid structure is proposed, which is proved to be a feasible design of a heat pipe for the semi-passive thermal protection system (TPS). The effects of different material of the exterior surface on the temperature distributions are investigated. The effect of the half wedge angle, the design length and porosity of the wick is also investigated to find the effect of the geometry of the structure of the leading edge on the operation of the heat pipe.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
