Investigation on the quality analysis of 1 312 single crown digital models.

Abstract

This study aimed to investigate the quality of single crown digital models, enhance communication between clinicians and technicians, and improve the quality of restorations to further reduce remake rate. A total of 1 312 single crown digital models (180 anterior teeth, 294 premolars, and 838 molars) were randomly selected from a large commercial dental factory. The digital models were evaluated by three investigators with the same working experience with the same intraoral scanning system (CEREC). CEREC SW 4.4 was used in capturing the images of single crown preparations, and prepCheck 3.1 was used in evaluating the quality of single crown digital models. Approximately 6.55%, 0.08%, 81.17%, 19.59%, and 22.48% of 1 312 single crown digital models did not meet the standards of the undercut, surface quality, margin quality, buccal-lingual taper, and mesiodistal taper, respectively. Moreover, 23.25%, 28.51%, 28.43%, and 28.35% of the investigated single crown digital models did not meet the standards of the buccal inclination taper, lingual inclination taper, mesial inclination taper, and distal inclination taper, respectively. The quality of anterior teeth, premolars, molars at the margin quality, buccal-lingual taper, mesiodistal taper, buccal inclination taper, lingual inclination taper, mesial inclination taper, and distal inclination taper significantly varied in the evaluation results (P<0.01). In addition to the undercut and surface quality met the standard, the overall situation of the quality of the single crown digital preparation model was poor, and the quality of the preparation needs to be improved urgently.