Investigation on the multidirectional crack vibration induced by rock fracture

Abstract

Understanding crack vibrations in rock under load is crucial for comprehending and predicting rock failure. With this motive, a novel multidirectional crack vibration (MCV) monitoring experiment is carried out using miniature vibration acceleration sensors with directional sensing. The obtained results show that the crack surface produced by uniaxial compression failure of rock is rough and its direction is variable. Furthermore, the volume distribution of the sample after failure is uneven, and there is a noticeable difference in mass between the broken samples on either side of the crack. Different directions of crack vibration signals were detected during rock failure, all exhibiting a strong temporal correspondence with the stress drop, but the amplitudes and main frequencies of the vibrations differ across directions. The fracture-induced crack vibration is a typical low-frequency signal, with the highest recorded frequency at 55.63 kHz and the lowest being 0.86 kHz, with the main frequency mostly below 25 kHz, which is notably lower than acoustic emission. This difference suggests that fracture-induced crack vibration and acoustic emission are distinct physical quantities. The disparities in rock vibration amplitude and main frequency among different directions, especially those perceived by opposing sensors, indicate that the two sides of the crack cannot be considered as the same vibration system. The analysis shows that the fracture-induced crack vibration of rock under load is damped vibration with a small and variable damping. Besides, due to the difference in vibration parameters on both sides of the crack, their vibration amplitude and frequency are also different. The miniature acceleration sensors used in this work can effectively capture MCV during rock failure and can be employed to further investigate the vibration precursor of rock instability failure, so as to develop appropriate assessment and prediction methods for underground dynamic disasters.