Abstract
Abstract The lubricity of newly designed self-lubricating 70-mm-bore angular contact ball bearings was tested using a special bearing tester under thrust load of about 20 kN and speed of about 20000 r/min in liquid nitrogen. The test bearing was characterized with the pure polytetrafluoroethylene (PTFE) retainer coupled with the Ag-based lubricant film initially deposited on bearing raceways. After running for 1200 and 2400 s respectively, the states of the PTFE transfer films on the surfaces of the balls and raceways as well as the wear state of the Ag-based solid lubricant film for each tested bearing were analyzed mainly by scanning electron microscopy and X-ray photoelectron spectroscopy. The results indicated that good lubricating conditions were obtained for all tested bearings. The newly designed self-lubricating ball bearing could run steadily for more than 2400 s under high speed, heavy load and at cryogenic temperature conditions. The formation and the evolution of PTFE transfer films with bearing operation are mainly discussed according to the relevant analysis.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have