Investigation on the determination of flow direction using two parallel cylindrical hot film sensors

Abstract

Measurement of instantaneous air flow velocity with high frequency can be carried out by using a hot wire anemometer (HWA). HWA works on the basis of heat transfer rate from hot wire to the fluid flow, therefore directional identification of the air flow using hot wire anemometer is a difficult task. By using two parallel cylindrical hot film sensors a probe was built. By considering the wake and heat effect of the upstream sensor on the downstream sensor, direction of the air flow can be identified. In this work, the wake and heat effect resulting from the upstream sensor to the velocity measurement, by the downstream sensor was studied. This measured velocity is dependent of the following factors namely; air velocity, upstream sensor overheat ratio, distance between the two sensors and turbulence intensity of the flow. As a result it was found that the manufactured probe with sensor distance of 1 mm apart is capable of measuring reverse flow measurements of up to 20 m/s for a moderate turbulent flow.