Investigation on the characteristics of porosity, melt pool in 316L stainless steel manufactured by laser powder bed fusion

Abstract

Pores are among the primary defects in 316L stainless steel when fabricated through laser powder bed fusion (L-PBF). To better understand and precisely control the formation behavior of pores in the L-PBF-manufactured 316L stainless steel, effects of L-PBF process parameters on the melt pool and pore characteristics have been investigated. A method utilized for extreme values statistics analysis was also applied to investigate and predict the sizes of pores. Relationships among the count of measurements, the laser energy density, the reduced variate, and the maximum pore size were revealed. The findings showed an overall increase in melt pool depth as the laser energy densities was raised, yet the magnitude of this growth weakened as the laser energy density continued to increase. Conversely, it was discovered that the connection between the width of the melt pool and the density of laser energy exhibited a markedly less distinct correlation. As laser energy density escalated, there was a shift in the melt pool mode from conduction-based to a transitional phase, and upon further elevation of the laser energy density, it transitioned to keyhole mode. To obtain a reliable statistical analysis of pores, at least 40 measurements should be acquired for the estimation of the pore sizes by taking comprehensive consideration of time cost. Beside, in all three melt pool modes, at a fixed observation area, the maximum size of pores generally decreased with the escalation in laser energy densities.