Abstract
Ti-6Al-4V ELI (Grade 23) is highly recommended for bio-materials and due to its low thermal conductivity and chemically reactive properties, machinability is poor. Thus the current work emphasized on the selection of appropriate cooling technique and optimal cutting parameters for machining of Ti-6Al-4V ELI alloy with sustainability analysis for surface roughness, flank wear and cutting power. Initially, the cutting performances under dry, flood and MQL environments are compared and MQL is observed to better performed. At lower speed (70 m/min), MQL exhibited 26.38% and 19.69% lesser surface roughness relative to dry and flood cooling individually. At the same cutting condition, MQL assisted cutting resulted in lower flank wear relative to dry (157. 33%) and flood cooling (40%). Further, a detailed investigation has been made under MQL through Taguchi L18 design of experiments. The major mechanisms for flank wear are found to be abrasion, chipping and notch wear. Optimal data set through Grey relational analysis is found to be v1 (70 m/min), f1 (0.1 mm/rev) and d1 (0.1 mm) and improved. Quadratic regression model is found to be significant for prediction of responses. Sustainability Pugh matrix assessment revealed that MQL environment enhanced the economical, technological as well as environmental and operator health aspects. Reduction of energy consumption by 53.96% and savings of carbon footprints by 68.46 kg of CO2 observed under MQL at optimal conditions and thus saves manufacturing cost.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have