Abstract
The working conditions of the ceramic cores are extremely harsh with the development of the preparation technology and improvement of the use conditions in the hollow blades, which brings forward high request for the preparation and properties of the ceramic cores. In this paper, silica ceramic powders were firstly coated by the silicon resin. The obtained composite powders were used to prepare the ceramic cores by the dry pressing method. And the phase compositions, microstructure and properties of the ceramic cores with the sintering temperatures were investigated. The results showed that the composite powders prepared by the coating showed good formability. The sintering temperature promoted the formation of the cristobalite. With the increase of the sintering temperature, the porosity of ceramic cores gradually decreased, the shrinkage rate and bulk-density increased. The prepared ceramic cores at 1250°C had highest bend strength of 19.25Mpa.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
