Investigation on occupational hazards in 20 automobile manufacturing enterprises in Shandong Province

Abstract

Objective: To investigate the current situation of occupational hazards in automobile manufacturing enterprises in Shandong Province. Methods: From February to May 2019, the convenience sampling method was adopted to conduct on-site occupational health surveys with 20 automobile manufacturing enterprises in Shandong Province as the survey subjects, to detect the occupational hazard factors in the workplaces and individual exposure levels, and to analyze the occupational health check results of operators. Results: There were 13 small-sized, 4 medium-sized and 3 large-sized enterprises among the 20 automobile manufacturing enterprises. The detection results of benzene and toluene in the workplaces met the occupational exposure limits, and the detection results of welding fumes, manganese and its compounds, and xylene exceed the occupational exposure limits. The maximum short-term exposure concentration (C(STE)) of welding fume in the air of workplaces was 24.23 mg/m(3), and the over-standard rate was 11.0% (16/146) . The maximum time-weighted average concentration (C(TWA)) of welding fume of operators is 10.60 mg/m(3), and the over-standard rate was 11.0% (8/73) . The maximum C(STE) of manganese and its compounds in the air of workplaces was 0.879 mg/m(3), and the of manganese and its compounds of operators was 0.175 mg/m(3), and the over-standard rate was 5.7% (4/70) . The maximum xylene C(STE) in the air of workplaces was 230.00 mg/m(3), and the over-standard rate was 3.9% (2/51) . The maximum xylene C(TWA) of operators was 70.40 mg/m(3), the over-standard rate was 3.6% (1/28) . Among the 4775 workers exposed to occupational hazards, 38 (0.80%) were suspected of electric welder's pneumoconiosis, 27 (0.57%) were suspected of manganese poisoning and 31 (0.65%) were suspected of chronic low-concentration benzene and benzene series poisoning. The detection rates of suspected occupational diseases among workers in small and medium-sized enterprises were relatively high, 2.86% (30/1048) and 4.51% (51/1132) respectively. There was a statistically significant difference in the detection rates of suspected occupational diseases among the operators of different scale automobile manufacturers (P<0.05) . Conclusion: The exposure levels of electric welding fumes, manganese and its compounds in welding jobs and xylene exposure levels in spray painting jobsin Shandong Province's automobile manufacturing enterprises are more serious. The supervision and management of occupational hygiene should be strengthened, the working environment should be improved, and the health of welding and painting workers should be protected.