Investigation on multi-parameter of hydrate-bearing synthetic sediment during hydrate replacement process: A in-situ X-ray computed tomography study

Abstract

Carbon sequestration can be achieved by carbon dioxide replacement in natural gas hydrate exploitation, which reducing greenhouse gas emissions and providing an effective solution to address climate change, while simultaneously protecting the environment and promoting sustainable energy development. Gas replacement can achieve gas exploitation, gas storage, and stability enhancement simultaneously. However, time-varying microstructure evolution of the hydrate-bearing sediment (HBS) during this process remain a large amount of uncertainty. In this study, with microfocus computer tomography, hydrate replacement process is realized using xenon gas to replace krypton hydrate. During this period, the initial hydrate saturation and effective confining pressure were 63 % and 1 MPa respectively, the results were obtained as follows: 1. Hydrate occurrence dynamically adjusted during replacement process due to the “barrier effect” and “diffusion effect”. 2. Dissociated water migration occurred in the sediment, and this induced local hydrate enrichment temporarily and blockages, but the blockages were eventually dredged with the dissociation of the Kr hydrate. 3. The sphericity and surface roughness of the hydrate particles were slightly improved, the pore space connectivity was well enhanced, and both tortuosity and absolute permeability was better strengthened after replacement process, where the absolute permeability was increased by 225.23 %, though the blockage occurrence temporarily weakened this strengthener.