Investigation on electrochemical removal of CaCl 2 from LiCl–KCl melts

Abstract

In order to investigate the possibility of electroseparation of CaCl 2 from CaCl 2–LiCl–KCl melts prior to Li + reduction, Ca 2+ and Li + ions reduction potentials in the melts were investigated by cyclic voltammetry (CV) and chronopotentiometry (CP) on both a tungsten and a tin electrodes. The potential difference between the two ions in CaCl 2 (0.5 wt%)–LiCl–KCl melts was 0.2 V at 953 K analyzed by CV. About 0.4 V reduction potential difference between Ca 2+ and Li + ions was observed on chronopotentiograms recorded on a tungsten electrode in CaCl 2 (2.0 wt%)–LiCl–KCl melts either at 723 K or 953 K, which can meet the requirements of total electroseparation. Tin electrode can shift the reduction potentials of Ca 2+ and Li + to more positive ones and also can improve Ca deposition rate and removal efficiency. After 3.0 h electrolysis on solid tungsten at −3.4 V vs. Cl 2/Cl − and liquid tin cathode at −3.0 V vs. Cl 2/Cl −, the Ca/Li (weight ratio) in the melts changed from 3/25 before electrolysis to 2.6/25 and 0.76/25 respectively, analyzed by ICP. Under stirring, even higher removal rates of 83.65 wt% and 94.66 wt%, corresponding to 0.54/25 and 0.16/25 of Ca/Li have been obtained for 3.0 h and 6.0 h electrolysis at −3.0 V vs. Cl 2/Cl − on a tin electrode. Clearly, stirring availably increases the Ca 2+ ions diffusion rate and its electrochemical reaction rate.