Investigation on effect of process parameter on surface integrity during electrical discharge machining of NiTi 60

Abstract

PurposeElectrical discharge machining (EDM) of hard materials like NiTi 60 alloys is important as it finds application in different sectors of engineering such as automobile, aircraft, biomedical, oil industries, etc.Design/methodology/approachThe first target of this investigation is to determine the effect of process parameters such as current, voltage, pulse on time and pulse off time on the material removal rate (MRR), surface roughness (SR) and white layer formation (WLT) for NiTi 60 smart material alloy. The secondary aim is to identify the presence of surface integrity parameters such as cracks, WLT, microvoids, globules and debris formation by using the scanning electron microscopy technique and with the use of ImageJ software for die sink EDM machining of NiTi 60 alloy.FindingsThe results reveal that current is significant for MRR, voltage and current influence SR, and for WLT, voltage is a significant factor. The experimentation study also shows the generation of oxide and carbide layers on the machined surface, which were evident with the use of the X-ray diffraction technique. The presence of these oxide and carbide layers causes to form WLT on the machined surface and thereby increases the hardness of the machined surface.Originality/valueHardness test was performed with Vickers hardness tester, which gives evidence for the increase in hardness of machined surface due to the generation of WLT.