Investigation on diffusion wear during high-speed machining Ti-6Al-4V alloy with straight tungsten carbide tools

Abstract

During high-speed machining Ti-6Al-4V alloy, high-temperature at the tool–chip interface and the concentration gradient of chemical species between tool material and workpiece material support the activation of diffusion process, and therefore the crater wear forms on the rake surface of the cutting tool at a short distance from the cutting edge. In this paper, the diffusion analysis was theoretically proposed. The constituent diffusion at the contact interface between tool material and Ti-6Al-4V alloy at high-temperature environment, the crater wear on the rake surface of the tool, and the chips collected from high-speed milling Ti-6Al-4V alloy with straight tungsten carbide tools were analyzed by the scanning electron microscope with energy dispersive X-ray spectroscopy. The constituents inside the tool could diffuse into the workpiece and the diffusion layer was very thin and close to the interface. Compared with the diffusion of tungsten and carbon atoms, the pulling out and removing of the tungsten carbide (WC) particles due to cobalt diffusion dominated the crater wear mechanism on the rake surface of the cutting tool.