Abstract
Process induced residual stresses are one of the main sources of defects such as (pre) mature matrix cracking during pultrusion of fiber reinforced polymer composite profiles. Recently, comprehensive process models have been developed to understand and describe the underlying mechanisms of the residual stresses in pultrusion processes. The predicted stresses however have not been validated with experimental measurements which are necessary to verify the implemented material models and assumptions in the process models. A hole drilling method with digital image correlation (DIC) is used in the present work to measure the transverse strain relaxation due to material removal in a pultruded thick composite profile (20 × 20 mm) made of unidirectional glass/polyester. The corresponding residual stress state is back calculated using the measured strains in a finite element based numerical model. The estimated level of transverse residual stress in the core of the profile was found to be 6.1 MPa in tension.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
