Abstract
This contribution investigates the springback behavior of several advanced high-strength sheet steels (TRIP, Dual-Phase, ferrite-bainite) with thicknesses up to 4 mm. Samples were tested by means of the bending-under-tension (BUT) test. This test proved very useful to discriminate constitutive models, while avoiding the interference of friction in the springback investigations [1,2]. However, the interpretation and numerical simulation of the test have to be carefully performed [3,4]. The applicability of several guidelines from the literature was investigated experimentally and numerically, in the context of thick AHS sheets. The monotonic decrease of springback as back force increased was confirmed for this category of sheet steels, and a general trend for the non-linear influence of the tool radius was observed. The influence of numerical factors on the predicted values of springback was investigated. Conclusions and simple guidelines are drawn from the analysis with industrial sheet forming applications in mind.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
