Investigation of the wetting of PCBs with SnCu (HASL) and Snimm finishes by SnZnBiIn solders

Abstract

PurposeThe purpose of this article is to establish why the wetting on PCBs with SnCu (HASL) and Snimm finishes in the presence of a flux is better than the wetting of those on a copper substrate. The practical aspect of the obtained results is the main goal of these investigations.Design/methodology/approachThe authors applied the wetting balance method for the wetting measurements at 230 and 250°C, in nitrogen atmosphere, in the presence of the ORM0 type flux. The PCBs with the SnCu (HASL) and Snimm finishes were investigated in the state “as received”. To establish the wetting properties of the SnCu (HASL) and Snimm finishes on the PCBs, wetted by the investigated SnZnBiIn alloys, the SEM and EDX analyses were performed.FindingsThe authors obtained very good wetting results of the PCBs with the SnCu and Snimm finishes, wetted by the SnZn7Bi3In4 alloys. By applying the SEM and EDX methods, it was possible to establish that the barrier layer which was created during the HASL process between the copper and the SnCu solder is efficient enough to protect the copper against the influence of the Zn atoms from the SnZn7Bi3In4 solder. This is the reason for an improvement of the wetting properties. An immersion tin finish does not create such barrier layer with the copper. It results in a worse wetting than for the SnCu finishes but a better one than that for the copper. Immersion tin dissolves in the alloys during the soldering and this process delays the reaction between the copper and the Zn atoms from the SnZn7Bi3In4 solder.Research limitations/implicationsIt is suggested that further studies are necessary for the confirmation of the practical application, but they should be limited to the reliability of the solder joint performance.Practical implicationsThe best wetting results of the PCBs with “tin finishes”, especially with SnCu, wetted by the SnZn7Bi3In4 alloy, at 230 and 250°C and in nitrogen atmosphere, suggest a possibility of a practical usage of the tin‐zinc‐bismuth‐indium alloys for soldering in electronics.Originality/valueThe wetting balance method combined with the SEM and EDX analyses were used as the quickest way to determine the mechanism of the better wettability properties in the case of the PCBs with the SnCu and Snimm finishes, wetted by the SnZn7Bi3In4 alloy, compared to those of the PCBs on the Cu substrate.