Investigation of the wetting behavior of coal tar in three phase systems and its modification by poloxamine block copolymeric surfactants.

Abstract

The removal of dense nonaqueous phase liquid mixtures (DNAPLs) from rocks and subsurface soils is an ongoing remedial challenge. Very often the wetting preferences of the system are not altered by exposure to the DNAPL. However, there are systems where the wetting properties of the solid phase have been altered from strongly water wetting by exposure to the DNAPL. In these cases some technique is necessary for reducing the work of adhesion between the DNAPL and the mineral surface. The focus of this report is the problems posed by coal tar in unconsolidated sands. It is shown that coal tar can alter the wetting properties of quartz, the principal component of sands, and is thus capable of adhering to the surface. In this investigation the ability of several members of the poloxamine family of polymeric surfactants to aid in the removal of coal tar from sand was evaluated. The poloxamines are tetrafunctional block copolymeric surfactants, which contain four poly(ethylene oxide)-block-poly(propylene oxide) chains joined to a central ethylenediamine moiety via the nitrogen atoms. Contact angle measurements of coal tar on a quartz surface immersed in aqueous surfactant solution and the interfacial tension between coal tar and aqueous surfactant solution have been measured. Coal tar/water interfacial tensions are reduced to values in the region of 2 mN m(-1) at surfactant concentrations of approximately 0.1 w/v %. Poloxamine surfactant impact on the static contact angle is more complex. In some cases the polymeric surfactants alter the wetting behavior from strongly water wetting to weakly water wetting. However, other poloxamines appear to have little if any impact on the contact angle, which remains strongly water wetting. The foregoing measurements have then been used to calculate the work of adhesion of the coal tar to quartz and the results qualitatively compared with the concentration of surfactant solution required to visually demonstrate the complete de-adhesion of coal tar to the quartz. It is shown that at surfactant concentrations below the critical micelle concentration (cmc) of the surfactant, the work of adhesion can be reduced sufficiently to ensure complete removal of coal tar from both quartz and sand.