Abstract
The pivoting friction of ShKh15 steel over the flat surface of a prism made of R6M5 and 10R6M5-MP steel was investigated. It was proved that, in the steady wearing mode, the pivoting friction moment is steady as well. It was shown that the change in the pivoting friction moment from the load for R6M5 steel does not stay within the boundaries of one linear dependence and for the powder steel 10R6M5-MP is linear. Wear of a ball made of ShKh15 steel in the case of friction by 10R6M5-MP steel is more intense as compared with the friction by R6M5 steel, and the friction moment, on the contrary, has a smaller value. As a result, cutters made of 10R6M5-MP steel will be more effective and energy saving during cutting of ShKh15 steel.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
