Abstract
Summary Water huff ‘n’ puff is an effective enhanced oil recovery (EOR) technology for tight oil reservoirs. However, the oil production of horizontal wells declines seriously after several huff ‘n’ puff cycles, and a large amount of oil is still trapped in the reservoir due to the heterogeneity of fracturing sections. The temporary plugging agent had been used for plugging high-permeability areas and thus diverting the following fluid into small permeability areas. It would improve the sweep efficiency of flooding fluid, enhancing oil recovery. However, the use of the oil-soluble particulate temporary plugging agent in the water huff ‘n’ puff application is barely reported. Therefore, the feasibility and influencing factors of oil-soluble particulate temporary plugging agent-assisted water huff ‘n’ puff (TAWHP) in enhancing oil recovery was investigated in this study. First, based on the evaluation of the performance of the oil-soluble particulate temporary plugging agent, the oil recovery of fractured core samples with different apertures for water huff ‘n’ puff and TAWHP was compared via the parallel-core experiment to verify the feasibility of TAWHP in enhancing oil recovery. The temporary plugging agent had good oil solubility, a low residual rate in the formation, and little damage to the formation. The oil recovery yielded by TAWHP was 5.17% higher than the traditional water huff ‘n’ puff process. More oil (i.e., about 1.71%) could be expelled from the fractured core samples with a small aperture. It indicated that the EOR performance yielded by water huff ‘n’ puff after several cycles could be enhanced by adding the oil-soluble particulate temporary plugging agent. After that, a mathematical model of TAWHP was established to investigate the effect of TAWHP parameters on EOR performance. The simulation results showed that the cumulative oil production increased with the increase in injection time of the temporary plugging agent solution, but the trend would level-off after 10 minutes. Moreover, as the diversion index increased, the effect of the injection rate on cumulative oil production gradually enhanced while the effect of the soaking time gradually weakened. Furthermore, the difference in cumulative oil production at different diversion indexes gradually increased as the huff ‘n’ puff cycle increased. This work could provide theoretical guidance for water huff ‘n’ puff enhancing oil recovery after several cycles.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have