Abstract
AbstractBetafite and zirconolite occur in Ti-rich hydrothermal veins emplaced within dolomite marble in the contact aureole of the Adamello batholith, northern Italy. Zirconolite contains up to 18 wt% ThO2 and 24 wt% UO2, and exhibits strong compositional zoning. Some zirconolite grains were corroded by the hydrothermal fluid. Betafite, the Ti-rich member of the pyrochlore group, often occurs as overgrowths on zirconolite. The betafite is weakly zoned and contains 29-34 wt% UO2. In terms of end -members, betafite contains approximately 50 mole percent CaUTi2O7 and is the closest known natural composition to the pyrochlore phase proposed for use in titanate waste forms. Amorphization and volume expansion of the betafite caused cracks to form in the enclosing silicate mineral grains. Backscattered electron images reveal that betafite was subsequently altered along crystal rims, particularly near the cracks. EPMA data reveal little difference in composition between altered and unaltered areas, except for lower totals, suggesting that alteration is primarily due to hydration. The available evidence demonstrates that both betafite and zirconolite retained actinides for approximately 40 million years after the final stage of vein formation. During this time, betafite and zirconolite accumulated a total alpha -decay dose of 3-4 x 1016 and 0.2-2 x 1016 α/mg, respectively.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.