Abstract
Selective laser sintering (SLS) with polymers is currently in transition to the production of functional components. Nevertheless, the potential to revolutionize conventional production processes is confronted by newly imposed requirements regarding reliability and reproducibility. To ensure that the requirements are fulfilled, the aging mechanisms occurring in polymers are compensated by recycling strategies, such as fraction-based mixing of a defined ratio of new with recycled powder. Although various mixing ratios for the reuse of the material in SLS have been investigated, there is insufficient knowledge of suitable mixing parameters for homogeneous and gentle mixing of the powder fractions. This work therefore focused on the influence of potentially suitable mixing parameters identified in a previous study on the ongoing powder and component properties in SLS using polyamide 12 and a constant refreshing rate. Regarding the powder properties, the intrinsic properties and density of the powders were investigated. Regarding the component properties, mechanical properties, sinter density, and surface quality were investigated. Decreases in the powder density and the component properties were measured by increasing the number of process cycles. Taking into account the determined powder and component properties, the selected mixing parameters enabled a homogeneous and gentle mixing of the powder fractions.
Published Version (
Free)
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
