Investigation of the homogeneity of Cu‐Ni sintered materials using microprobe

Abstract

AbstractThe application of various parameters for the estimation of the degree of homogenization of CuNi sinters is investigated. For this purpose specimens were prepared with different Ni contents, different degrees of initial porosity and different sintering periods. Analysis is done by means of point and line technique. The following parameters were used: standard deviation from the mean Ni content, \documentclass{article}\pagestyle{empty}\begin{document}$ S_c = \sqrt {\frac{1}{n}\sum\limits_{i = 1}^n {\left({c_i - \bar c} \right)^2 } } $\end{document}, variation coefficient \documentclass{article}\pagestyle{empty}\begin{document}$ v = \frac{{S_c }}{{\bar c}} $\end{document}, maximum concentration grapient of nickel, \documentclass{article}\pagestyle{empty}\begin{document}$ g = \left({\frac{{dc}}{{dx}}} \right)_{\max } $\end{document} and the relation of the minimum to the maximum Ni concentration in different points of the sinter. – These parameters are enough precise for the representation of the degree of homogenization, but besides this the latter enables to express the homogeneity in the form of a fraction as measure for the homogeneity of a sinter.