Abstract
This research investigates the effects of electrode lead and tilt angles and dielectric fluid flow rate on material removal rate, tool electrode wear ratio, and surface roughness in near-dry electrical discharge machining (EDM) milling process. Computational fluid dynamics (CFD) model is developed to predict the dielectric fluid flow rate and qualitatively compare with the experimentally measured EDM material removal rate. The optimum lead angle, which maximized material removal rate and minimized tool electrode wear ratio, was found. The decrease in the lead angle has a negative effect on the roughness of machined surface. The increase in tilt angle reduces the material removal rate and increases the tool electrode wear ratio. The change in tilt angle does not have a significant effect on the surface roughness and can be used to prevent gouging in finishing EDM milling. This study shows that the material removal rate is linearly proportional to the mass flow rate of air and kerosene mixture, the tool electrode wear ratio is inversely related to the mass flow rate of air and kerosene mixture, and the average surface roughness does not have a good correlation with the flow rate of the mixture.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Machine Tools and Manufacture
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
