Abstract
The effect of steel fiber reinforcement on the shear behavior of prestressed concrete beam is studied using digital image correlation (DIC) technique. Steel fiber reinforced prestressed concrete (SFRPC) beams with fiber dosages of 0.5% and 1.0% by volume were cast and tested under shear. SFRPC beams were tested under a three-point bending configuration at a shear span (a) to depth (d) ratio of 2.4 to simulate shear dominant behavior. Other parameters such as compressive strength of concrete, prestressing reinforcement ratio and level of prestressing were kept constant. The kinematics of diagonal shear cracks including crack opening and crack slip were monitored using DIC based full-field strain measurement technique. The improvement in aggregate interlock and residual tensile strength at the crack tip due to the addition of steel fiber was reflected in the post-peak response of SFRPC beams. DIC analysis revealed that the full depth crack was formed in all the SFRPC beams before reaching their peak loads. The dilatant behavior was found to be consistent for all the test specimens (control and fiber reinforced concrete beams) up to peak load. The test results portray that the addition of steel fibers stiffens the post-peak response and reduces the crack opening and crack slip. Moreover, the failure mode changed from shear (brittle) to flexure-shear (less brittle) mode.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
