Investigation of the Effect of Nanoparticle-Stabilized Foam on EOR: Nitrogen Foam and Methane Foam.

Abstract

In recent years, studies conducted on foam stabilization have focused on nanoparticles by generating strong adsorption at the interface to stabilize the foam under harsh reservoir conditions. Meanwhile, the selection of a gas source is also of great importance for foam performance. In this study, a mixed system of surfactants was selected, and the foamability and foam stability of nitrogen and methane were evaluated according to the improved jet method. After adding modified SiO2 nanoparticles, the foam-related parameters were analyzed. The plugging abilities of the different foams were compared through core-flooding experiments, and the oil displacement effects of the different foams were compared through microfluidic experiments. The results show that the amphoteric surfactant betaine has an excellent synergistic effect on the anionic surfactant SDS. The methane foam produced using the jet method has a larger initial volume than the nitrogen foam, but its stability is poor. The half-life of the nitrogen foam is about two times that of the methane foam. After adding 1.0 wt % SiO2 nanoparticles to the surfactant solution, the viscosity and stability of the formed foam improve. However, the maximum viscosity of the surfactant nanoparticle foam (surfactant-NP foam) is 53 mPa·s higher than that of the surfactant foam. In the core-flooding experiment, the plugging performance of the methane foam was worse than that of the nitrogen foam, and in the microfluidic experiment, the oil displacement abilities of the methane foam and the nitrogen foam were similar. The plugging performance and the oil displacement effect of the foam are greatly improved by adding nanoparticles. The surfactant-NP foam flooding has a better oil displacement effect and can enhance the recovery factor by more than 30%. Under actual high-pressure reservoir conditions, although the stability of the methane foam is weaker than that of the nitrogen foam, some methane may be dissolved in the crude oil to decrease the viscosity after the foam collapses, which leads to the methane foam being the preferred method in oilfields.