Abstract
As the use of pulsed lasers in the manufacture of cooling holes in high-temperature gas-turbine engine components continues to increase, understanding the material behavior during laser-material interaction and the subsequent effects on hole quality becomes critical. In this study, atomic emission spectroscopy is used to monitor the optical characteristics of ejected material during percussion laser-drilling of Waspaloy over irradiance and pulse duration values in the ranges of 10–20 MW/cm2 and 0.3–1.1 ms, respectively. While irradiance is a widely used target parameter, it was experimentally determined that pulse duration had a larger impact on both the calculated electron temperature of the ejected material as well as on the thickness of residual resolidified, or recast, layer of material on the inside walls of drilled holes.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
