Abstract
Wire and rod drawing is widely used in metal forming processes to obtain products such as rods and wires. Rods having shaped sections such as square, rectangle and irregular section are necessary to produce connecting pins and components of transformers. Important characteristics of the shaped drawing process are the corner filling and inhomogenious factor of strain that influence the dimensional accuracy and the good quality of the product. In this paper, a three-dimensional rigid-plastic finite element analysis is used to simulate the drawing process of a square rod from a round bar. A finite element method is also used to investigate the corner filling, forming load, stress distribution and inhomogenious factor of effective strain under various process parameter conditions, including the reduction of area, the die semi-angle, and the friction factor
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
