Abstract
The purpose of this study was to investigate the dosimetric characteristics of the GAFCHROMIC® EBT3 film responding to alpha particle irradiation. Unlaminated GAFCHROMIC® EBT3 film pieces, were irradiated with a 30.055 kBq 241Am alpha source, at eight different dose levels, between 0 and 509 Gy. The irradiations were performed inside an enclosed box. Epson Expression 10000 XL scanner in transmission mode was used to digitize irradiated films 24 hours post-irradiations as 16-bit RGB images in tagged image file format (TIFF). Optical density (OD) values were obtained by following the OD theorem. Raw and normalized pixel values (PVnorm) from the red, green, and blue colour channels were sampled from a 3 × 3 mm2 region of interest. Calibration curves were created for both data sets (OD and PVnorm) and were fit accordingly. Monte Carlo simulations with the Geant4 toolkit were performed to establish a dose rate at the point within the sensitive layer of the film. An alpha dosimetry protocol for EBT3 films was obtained from the Monte Carlo calculated dose rate and dose calibration curves for alpha radiation were created. It is necessary to extend this study for different film types and compare to photon dosimetry calibration curves.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.