Investigation of the Demulsification Efficiency of Some Ethoxylated Polyalkylphenol Formaldehydes Based on Locally Obtained Materials to Resolve Water-in-Oil Emulsions

Abstract

Fourteen ethoxylated polyalkylphenol formaldehyde surfactants were prepared from locally sourced raw materials. These surfactants were used as demulsifiers to resolve asphltenic crude oil emulsions. Different factors affecting demulsification efficiency such as water:oil ratios, surfactant concentration, surfactant molecular weight, ethylene oxide content, alkyl chain length, and asphaltene content were investigated. From the data obtained it was found that the demulsification efficiency increases by increasing the concentration, alkyl chain length and water content in the emulsion. Also it was found that the increase of asphaltene content in the crude oil impeded the demulsification efficiency. The effect of molecular weight was studied and it was found that the demulsification efficiency was controlled by an optimum range of molecular weight between 3640 to 3810 for the family of demulsifiers studied. Regarding the effect of ethylene oxide content in the demulsifier structure, it was found that the maximum demulsification efficiency was obtaind at 40 units ethylene oxide. The maximum demulsification efficiency was obtained by TND5 (m.wt. = 3800, eo = 40 units). With this demulsifier 100% water separation was exhibited after 35 minutes at 150 ppm demulsifier concentration and 50% w/o emulsion. The surface, interfacial tension, and hydrophilic lipophilic balance (HLB) of the invistigated demulsifers were studied. The obtained results justified that they are strongly related to the demulsification effeciency.