Abstract
This works aims at the analysis and optimization of joining similar grades of stainless steel by TIG welding. TIG welding may use a filler material. There is a variant in the process which does not require filler material. Such process is known as Autogenous TIG welding process. The parameters like current, welding speed and gas flow rate are the variables in the study. The objective of this research is to determine the influence of various welding parameters on the weld bead of 316 SS by using Taguchi technique. A plan of experiments based on Taguchi technique method has been carried out. Orthogonal array, signal to noise (S/N) Ratio, Analysis of variance (ANOVA) are employed for studying the welding characteristics of material & to optimize the weld parameters. The result obtained are the output from each parameter, through which optimal parameters are found out for maximum tensile strength. It is found that -welding current followed by welding speed are major parameters influencing mechanical properties of welded joint
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.