Abstract
In this study, the carbon fiber reinforced polymer (CFRP) composite material was drilled using different parameters ([Formula: see text] and [Formula: see text] Point Angle, 30, 60 and [Formula: see text] cutting speed and 0.06, 0.08 and [Formula: see text] feed rate). Experimental parameters were designed according to full factorial design method and the results were analyzed using Taguchi L18 experimental design. The results of the study show that the lowest surface roughness values are 0.1958 and [Formula: see text]m with the cutting speed of 90 [Formula: see text] and feed rate of [Formula: see text] in the Point angles of [Formula: see text] and [Formula: see text], respectively. When the results of Anova analysis were evaluated, parameters (feed speed, cutting speed and end point angle) according to the effect ratios on surface roughness were formed at the rates of 41.06%, 33.13% and 5.07%, respectively. The most suitable parameters according to S/N ratios were determined using A2B3C1 factors for the average surface roughness.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
