Investigation of supercritical transition and evaporation process of a hydrocarbon droplet under diesel engine-relevant conditions

Abstract

Fuel spray supercritical transition in the diesel engine has been concerned widely, especially supercharged ones, however, whether the transition can significantly affect the fuel–air mixing under diesel engine-relevant conditions is an issue that still needs evaluating carefully. Thus, the transition and evaporation of individual n-heptane droplets in a nitrogen environment under various ambient conditions were investigated through a high-pressure evaporation model. The influence of ambient pressures on droplet lifetime (τlife) and evaporation rate constant (K) varies with ambient temperature. When Tr < 0.98, with increasing pressure, τlife first increases and then decreases, and K decreases. When 0.98 < Tr < 1.28, as pressure increases, τlife would increase even if K increases, because the increment of initial heat-up periods exceeds the decrease in quasi-steady evaporation periods. When Tr > 1.28, with increasing pressure, τlife decreases, and K increases. As the droplet heats up, the droplet interface is where the binary mixture would reach the critical mixing state if ambient conditions are high enough. Increasing ambient density decreases the minimum ambient temperature (Tm) required for the transition to occur. Above the Tm, transitions occur earlier with the increasing energy density of ambient gas. Increasing ambient density decreases the minimum ambient temperature required for diffusive fuel-gas mixing modes to dominate the mixing process. For droplets large enough to ignore gas–liquid interfacial thickness, the Tm required for the attainment of critical mixing states is almost independent of droplet diameter.