Abstract
The components made of steel sheet metal very important in todays industry. In order to be useful, those parts must comply with the design tolerances, such as shape, position and dimensions. The largest problem with the parts bended by using dies is the springing, because it violates the manufacturing tolerances. Therefore, it is vital to know a parts springback and springgo properties in advance, which is mainly dependent on the properties of the sheet metal and bending conditions.In this study, 0.9 mm AISI 400 S steel sheet metal was bended using V dies (30°, 45°and 60°) and punches (2 mm, 4 mm and 6 mm). After being removed from the bending dies,springback rates of the specimens were measured by using optical goniometer. With respect to the bending angles and punch radii, springback and springgo properties of the specimens were recorded by using a spreadsheet software and some figures are obtained.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
