Abstract
AbstractWe report new experiments investigating the failure mechanisms in shear, of thin layers of acrylic pressure‐sensitive adhesives (PSA). We have developed a novel experimental device able to shear a soft adhesive layer confined between a rigid hemispherical lens and a rigid glass substrate. Using the resources of in situ contact visualization, the nonhomogeneous deformation of the layer and the shear failure processes were observed optically. Depending on the rheological properties of the adhesive, ratios of the contact radius over the layer thickness of 10–30 were achieved, mimicking well the contact conditions encountered in a thin adhesive layer within a joint. When the adhesive was weakly crosslinked, we observed a fluid‐like behavior and could measure a reasonable value for the viscosity of the PSA, implying that flow can occur in the layer and failure will occur by creep. On the other hand, for a more crosslinked adhesive, closer to what is used in applications, a stick‐slip peeling behavior was observed, which involves a coupling between peeling mechanisms at the leading edge of the contact and interfacial slippage. Such a process suggests a failure by fracture rather than by creep. Interestingly, the peeling mechanisms and the associated stress levels change significantly when the layer becomes as thin as 20 μm, implying a fracture process that is controlled by a critical energy release rate in shear GIIc rather than by a critical shear stress causing failure of the interfacial bonds. © 2005 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 43: 3316–3330, 2005
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have