Abstract
AbstractMolecular orientation imparted during film fabrication is known to have a major effect on mechanical and thermal properties of both glassy and semicrystalline polymers. A three‐variable Box‐Behnken designed experiment was used to study the effects of die gap, die land length, and blowup ratio (BUR) on key linear low density polyethylene (LLDPE) blown film properties at constant final film thickness. In addition, differences in molecular orientation in the films were studied using optical birefringence and shrinkage methods. Measured key film properties were correlated to processing conditions and to measured molecular orientation. Die land length had no significant effect on film structure and properties. All LLDPE films exhibited about 70 to 80% shrinkage in the machine direction (MD) but expanded in the cross direction (CD). Most films exhibited negative in‐plane birefringence. MD Elmendorf tear was found to be inversely related to drawdown ratio and MD shrinkage, suggesting that MD tear is dependent primarily on amorphous chain extension and hence, amorphous segments orientation for LLDPE blown films. Dart impact strength of the films was shown to be related to MD shrinkage and to the induced surface roughness due to varying die gap. In a separate study, blown films of three high pressure LDPEs were fabricated under nearly identical conditions. No correlation was found between birefringence and shrinkage data on the LDPE blown films.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.