Abstract
The development of engine technologies and research on combustion processes are focused on finding new generation CI engines with simple control of the combustion process while efficiently maintaining desirable engine performance and meeting emission regulations. This comprehensive study on the relatively low hydrogen energy fraction (0.65–1.80%), supplied by onboard water electrolysers and on water injection, was performed on the performance and emission parameters of the CI engine. The article presents results of both experiment and simulation about the effect of hydroxygen and water injection on the combustion process, auto-ignition delay, combustion intensity, the temperature of the mixture and engine performance at BMEP of 0.2 MPa, 0.4 MPa, 0.6 MPa, and 0.8 MPa at a speed of 1900 rpm. For the first part, the test engine operated with diesel fuel with 3.5 L/min of hydroxygen gas supplied with an external mixture formation. The HHO has an effect on the combustion process at all range of BMEP. A decrease in BTE and increase in BSFC were noticed during tests. The peak pressure and the rate of heat release decreased, but the NOx decreased as well. The second part of experiment was performed with the injection of a substantial amount of water, 8.4–17.4 kg/h (140–290 cm3/min), and the same amount of hydroxygen. The injection of water further decreased the NOx; therefore, HHO and WI can be used to meet emission regulations. A simulation of the combustion process was carried out with the AVL BOOST sub-program BURN. The AVL BOOST simulation provided a detailed view of the in-cylinder pressure, pressure-rise, combustion intensity shape parameter and SOC.
Highlights
The contemporary development of the global economy is closely related to rising power demands and increased power consumption
An investigation [20] was performed on influences of the addition of hydrogen to the compression ignition (CI) engine fueled solely with RME and regular diesel fuel sold at a Lithuanian retail outlet, which corresponded to a blend of 7% RME with ULSD
The peak pressure, pmax, was lower when the engine was fed with a D+HHO mixture in comparison to the results when the engine was fed with pure diesel fuel (Figure 3)
Summary
The contemporary development of the global economy is closely related to rising power demands and increased power consumption. Over the last few decades, the increasing melt process of mountain glacial masses and the ice covers of the North and South Poles have been noticeable. The latter is especially dangerous for the planet, because global sea levels could rise by 60 m if all the ice were to melt. In 2017, global CO2 emissions reached 32.84 eGt CO2 , while the entire transport fleet reported emissions of 8.04 eGt CO2
Sign-in/Register to view highlights & summary Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call
