Investigation of micro-electro-discharge machining process parameters during machining of M2 hardened die-steel

Abstract

Micro-electro-discharge machining (micro-EDM) is a well-known micromachining method to create microstructures on hard-to-cut materials. To further exploit the capability of micro-EDM, the present research work investigates the effect of various important micro-EDM process parameters on the material removal rate (MRR), tool wear rate (TWR), and overcut (OC) during micro-cavity machining of M2-hardened die-steel. A Taguchi experimental design was used to study the effects of three process parameters namely pulse-on-time (Ton), peak current (Ip), and gap voltage (Vg). The experimental results showed that the most influencing process parameter in the present experimental investigation is peak current, Ip followed by pulse-on-time, Ton and gap voltage, Vg. Furthermore, a recent and effective method i.e. Measurement of Alternatives and Ranking according to COmpromise Solution (MARCOS) has been successfully employed to determine optimal process parametric combination for micro-EDM process to achieve maximum MRR and minimum TWR and OC during machining of micro-cavity on M2-hardened die-steel. From the present research investigation, the optimal micro-EDM process parametric combinations obtained for higher MRR, lower TWR and OC are found as 1 A of peak current, 30 μs pulse-on time and gap voltage of 60 V. Furthermore, through various scanning electron microscope micrographs of micro-cavities and micro-machined surfaces, analysis has been done to find out the micro-cavity with best geometrical accuracy and surface feature to validate the best and most ideal combinations of micro-EDM input parameters for micromachining operations. The results of this study show that micro-EDM is a promising process for machining M2-hardened die-steel. The optimization of process parameters using the MARCOS methodology can further improve the machining efficiency and accuracy of micro-EDM.