Abstract
The present experimental work is to prepare the Polymer matrix composites (PMCs) with help of Medical Solid Liquid wastes and Fly-ash along with epoxy resin. Hand layup technique is utilized to make 15 samples as per Response Surface Methodology which supports to decide optimal value of tensile strength according to hand-layup process considerations. Three parameter with three levels are selected for optimization work such as MSL waste (5–15 %wt), FA (3–9 wt%) and stir duration (5–15 min). these constraints changed the behavior of materials especially elongation property. The results of experiment show that tensile strength (TS) was improved from 43 to 62 MPa due to proper mixing of Al chosen particles in PMCs and also reveals that the optimized TS (62 MPa) was found for a input casting variables (MSL-10 %wt.,FA-9 %wt & ST-5 min) in design expert software (DES).
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
