Abstract
Abstract Heat transfer and flow characteristics under air-water Taylor flow in a square microchannel with T-junction were investigated in this work. Different hydraulic diameters of models were discussed numerically by VOF method. Flow patterns such as bubbly flow, slug flow, annular flow and churn flow were identified by both numerical simulation and experimental methods. Simulation results including bubble formation process, bubble length, bubble velocity, void fraction and heat transfer fit well with literature data. The pressure differential of two sides in gas phase played an important role in bubble development. The gas and liquid superficial velocities were found to have a significant impact on bubble behavior. And the higher liquid viscosity would promote higher bubble velocity, also enhance heat transfer, but weaken the void fraction. The results showed a tiny but not ignorable effect of geometric dimensioning on bubble and liquid slug lengths. An appropriate correlation was proposed to estimate bubble length, and the deviation was −10 ~ + 15 %. By using moving frame of reference technique, the internal circulations inside the moving slugs were displayed more clearly.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Chemical Reactor Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
