Abstract
In the paper, the experimental study of grinding process of 2024Al/SiCp composites with the electroplated diamond wheel was conducted. The results indicate that the surface roughness of the workpiece is between 0.554 μm and 1.2 μm. Increment of the spindle speed, reduction of the cut depth and decrease of the feed speed make the surface roughness value reduce. After grinding, compressive stresses on the machined surface can be obtained. During grinding, the normal grinding force is greater than the tangent force and the grinding forces increase as the increase of the feed speed and depth of cut.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.