Abstract
In this article, smoothed particle hydrodynamics method is applied in order to study the free surface flow generated by two-dimensional planing flat plate. For this purpose, a two-dimensional smoothed particle hydrodynamics code is developed and validated by the well-known dam breaking problem. Four trim angles and three different velocities are considered to perform a parametric study to examine their physical effects. The obtained results from smoothed particle hydrodynamics are compared against the corresponding Reynolds-averaged Navier Stokes solutions. It is observed that at lower velocities, there exists a good agreement between the smoothed particle hydrodynamics and Reynolds-averaged Navier Stokes solutions, while at higher velocities, some inconsistency is observed. A brief discussion is presented to clarify the physical reasons behind the increase of the velocity and the height of the spray with the trim angle. Some formulas have also been derived to examine the variation of the ratio between the final wetted length of the flat plate and the initial wetted length at different velocities and trim angles.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Proceedings of the Institution of Mechanical Engineers, Part M: Journal of Engineering for the Maritime Environment
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
