Abstract
Purpose: The useful data and information during the sand compaction process steps should be collected. Direct measurement methods of the sand mould properties during the actual moulding process are not adopted yet. Design/methodology/approach: In this work, a remote control system [1] have been integrated into a new flowability sensor [2]. Findings: To overcome the complexity of the tools and equipment that existed in laboratory, and in foundry. Research limitations/implications: In order to investigate, and control behavior of the moulding process of bentonite-bonded green sand process, the sensors have been equipped with the Bluetooth technology for a wireless transmission of the measured data to computers. Originality/value: This technique contributes to improve of the compaction process based on the non-destructive tests, enhances prediction of the optimum parameter conditions, and reduced the energy, and the compaction time consumed for the green sand moulding process.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
