Investigation of ductile damage in dual phase steel during tensile deformation by in situ X-ray computed tomography

Abstract

In situ synchrotron radiation X-ray computed tomography (CT) is used to understand the void nucleation and growth behaviour of dual phase (DP) steel, DP800, during uniaxial tensile deformation. The voids were identified post mortem as having nucleated primarily in the (41 vol%) martensite phase. The behaviour of individual voids was found to be broadly in line with a Rice and Tracey style growth model (their volume increasing by a factor of 10), while the mean void size was broadly in line with a model that included the continuous nucleation of new voids, as well as the growth of existing voids, throughout straining. Voids tended to elongate during uniaxial (low stress triaxiality) straining, but then to dilate more isotropically as necking led to increased triaxiality. One large pre-existing void was found to elongate quicky at first, but then for growth to slow, presumably because it was not located in the highest triaxial stress (necked) region. Perhaps surprisingly the average size of the void population grows only slowly (by a factor of 2) during straining; this is because while the size of each void grows, new small voids are always being nucleated. Finally, the changes of stress triaxiality and shear stress state during tensile deformation of the square cross-section smooth tensile specimen are investigated via finite element modelling, to qualitatively assess the impact of sample geometry on void nucleation behaviour and fracture strain in the current study.